Materials

• 2 48in.x24in. Pine Boards (Menards)
• 3 1inx2in.x8ft. Pine Boards
• 4 4in.x3/8in. Lag Bolts
• 4 3/8in. urathane lined wingnuts
• Quart Varnish
• Large Decal

Tools

• 6in. hole saw (or Jigsaw)
• Drill
• Saw
• 9/16in. Wrench
• 3/8in. Drill bit
• Wooster Oil Based Brush 3 inch

Tape where you will be drilling with your hole saw may help prevent chipping. The center of the hold should be at the center of your board and the top of the hole should be 6" from the edge.

The top of board should be about 12 inches from the ground.

Don't sand it too smooth (or at all) or the bags will slide off.